Aeon labs multisensor firmware update

If you’re in need of assistance with any of Aeotec’s Z-Wave range, the best place to start is with our digital user guides. These include step by steps details on how to setup and use each of our products, along with links to download any firmware updates that may have been released. Access them by following the links below. Update Multisensor firmware via HomeSeer.

Our guide to upgrading Multisensor firmware via HomeSeer can be found by following the given link. Vera Edge, as with all other Z-Wave plus devices, uses a Sigma Designs 5series Z-Wave chip. It is 1 Z-Wave Plus.

However, in order for it to update you Aeon device’s firmware over the air, Aeon labs would need to provide the firmware update in a package that would be compatible with and run on Vera. I went down the path to update them, and seem to be stuck as I don’t have a Z-wave stick. It led me to think about the pain that I’ve always had updating firmware on the Aeon Multisensor 6’s (I use them exclusively).

It uses the latest chips and firmware for cutting-edge performance. MultiSensor has the newest version of Z-Wave built right in. That Z-Wave is Gen5. I’m guessing most people will be at 1. I will probably post the details for this in another thread. Should work with any Aeon device with OTA firmware updates.

Only available with. Cyberk, I just got this response from Aeon regarding the firmware update. Sorry to tell you that you need to unpair Multisensor from your ISY gateway. Best regards, Sonny Sun.

Field Application Engineer. För att uppdatera enheterna via Z-Sticken så laddar ni ner rätt firmware och startar. According to this website, you can update the multi sensor firmware with a PC, but you can’t use the included USB cable as it only supports power. Obtain the correct USB data cable and you can update the firmware. Gendevices offer peak performance and quality.

Aeon Labs Multisensor 4-and Vera beta firmware. Exclusive to Aeotec , they utilise Z-Wave 7series, a near-on 3x reduction in power consumption, a a improvement in wireless range, and 5 better battery performance. As many others have noticed the Multisensor temperature sensors start reporting in Celsius and soon after change to Fahrenheit. It’s built around the latest Z-Wave 5series chip and firmware , providing a greater wireless range and a 2 faster communication speed over previous Z-Wave products. Electronics Motion sensor.

I have appended the document recieved from the tech support yesterday. There are some parameter values that is incorrect when adding the multisensor to the Zipabox. My shows up in ISY as ZW 0Binary Sensor, ZW003_- Binary Sensor with a little box icon and ZW 0Multilevel Sensor, ZW003_1- Multilevel Sensor with a light bulb icon. The ZW 0Binary Sensor shows ON and 1 The ZW 0Multilevel Sensor shows 70. I bought one to track humidity in my bathroom and it reports new values every minutes.

I need it to report every minute for it to manage my bathroom fan properly. I know that’s a battery drain… that’s why it’s plugged in. The manual indicates it can be changed with a z-wave parameter field.

The Assosiation Group is set to for Settings, for Viewing I cant set a value. Waking up on battery is off. Parameter 1is 224. Anyone knows what is wrong ? Put Vera in inclusion mode. It’s built upon the latest Z-Wave 5series chip and firmware , offering a greater wireless range and a 2 faster communication speed over previous Z-Wave products.

Hallo, habe heute meinen Aeotec Multi-Sensor bekommen. Weil er Probleme mit den Werten macht, wollte ich nun mal schauen was er für eine Firmware drauf hat. Wo finde ich die eigentlich?

This topic is now archived and is closed to further replies.